Dell OptiPlex 7090 Tower Service Manual - Page 27
Solid-state drive, Installing the M.2 2230 PCIe solid-state drive
![]() |
View all Dell OptiPlex 7090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Solid-state drive Installing the M.2 2230 PCIe solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure. Steps 1. Align the notch on the solid-state drive with the tab on the solid-state drive connector. 2. Insert the solid-state drive at a 45-degree angle into the slot on the system board. 3. Replace the screw (M2x3.5) to secure the M.2 2230 solid-state drive to the system board. Next steps 1. Install the side cover. 2. Follow the procedure in after working inside your computer. Removing the M.2 2280 PCIe solid-state drive Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. About this task The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure. Removing and installing components 27
![](/manual_guide/products/dell-optiplex-7090-tower-service-manual-727a9f8/27.png)