Dell PowerConnect B-RX8 Installation Guide - Page 75
exactly the same for interface, management, and switch fabric modules.
View all Dell PowerConnect B-RX8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Installing a BigIron RX-32 switch 2 NOTE When inserting the module into the chassis, make sure that the faceplate doesnot overlap with the faceplate of an adjacent interface module. 5. Push the ejectors in until they are flush with the module front panel. This action will fully seat the module in the backplane. Modules have a snug fit for maximum EMI protection. FIGURE 42 Installing a module in a BigIron RX-32 chassis Pwr Active Pwr Active Pwr Active Pwr Active Pwr Active Pwr Active Pwr Active Pwr Active Pwr Active NOTE The installation instructions for installing modules shown in the following illustrations are exactly the same for interface, management, and switch fabric modules. 6. Tighten the two screws at either end of the module front panel by pushing them in and turning them clockwise. Then, tighten the screws further using the flat-head screwdriver. BigIron RX Installation Guide 63 53-1001811-01