Dell PowerEdge 1655MC Replacing the Server Module Board - Page 16

www.dell.com | support.dell.com While pulling down on the securing clip, press down on the server module board and slide it backward out of the enclosure. See Figure 1-9. Figure 1-9. Removing and Installing the Server Module Board grounding pad retaining tabs alignment notches enclosure securing clip Installing the Server Module Board CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Unpack the new server module board. 2 Align the server module board's alignment notches with the enclosure's retaining tabs. See Figure 1-9. 3 Press down on the server module board and slide it backward until the enclosure retaining tabs are resting on the grounding pads and the securing clip snaps over the server module board. See Figure 1-9. Installing the Processor CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1-12 Replacing the Server Module Board