Dell PowerEdge 1655MC Replacing the Server Module Board - Page 8

www.dell.com | support.dell.com The following is an example of the display if two drives are installed in mirrored mode: HBA ID LUN VENDOR PRODUCT 0 00 Dell VIRTUAL DISK 0 70 LSI Logic 1020/1030 REV 1000 1000c00 SYNC 320.0 WIDE 16 16 CAPACITY 18203 MB Table 1-1 lists the possible messages displayed for mirrored mode and the actions required. Table 1-1. Mir rored Mode Messages and Actions Message Action Logical drive optimal Go to "Replacing the Server Module Board." Logical drive resynchronizing Go to "Manually Deconfiguring Mirrored Mode." NOTICE: If this message is displayed, press immediately before the server module boots to the operating system. Logical drive degraded A hard drive is faulty. See "Troubleshooting Hard Drives" in your Installation and Troubleshooting Guide. Manually Deconfiguring Mirrored Mode 1 Press to reboot the server module. The following message is displayed during POST: Press CTRL-M to start LSI logic configuration utility NOTE: If you are using console redirection, you must press . 2 Press or to access the LSI utility. 3 Press to access the Adapter Properties Menu. 1-4 Replacing the Server Module Board