Dell PowerEdge 1655MC Replacing the Server Module Board - Page 7

Figure 1-1. Turning Off the Server Module power indicator power button Verifying the Hard-Drive Mirroring Mode 1 Ensure that the server module is turned on. See Figure 1-1. 2 Monitor the POST progress. When the POST reaches the PERC 4/im, either one or two SCSI drives are listed with their IDs (nonmirrored mode) or one SCSI drive is listed as a virtual disk (mirrored mode). The following is an example of the display if there are two drives installed in nonmirrored mode. If this display is seen during POST, proceed to "Turning Off the Server Module" and then "Replacing the Server Module Board." HBA ID LUN VENDOR PRODUCT 0 00 Fujitsu MAN3184MP 0 10 Fujitsu MAN3184MP 0 70 LSI Logic 1020/1030 REV 5507 5A01 1000c00 SYNC 160.0 160.0 320.0 WIDE 16 16 16 CAPACITY 18211 MB 18211 MB NOTE: Only one drive is listed if only one drive is installed in the server module. Replacing the Ser ver Module Board 1-3