Dell PowerEdge 2550 Rack Installation Guide - Page 21
center brackets are facing upwards.
View all Dell PowerEdge 2550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Figure 1-11. Installing the Slide Assemblies for Center-Mount Configuration 12-24 x 0.5-inch Phillips screw (2 per bracket) right slide assembly shoulder washer (2 per bracket) locking nut (2 per bracket) Flush-Mount Installation To prepare the RapidRails slide assemblies for flush-mount installation in the 2-post rack, perform the following steps: 1 Locate the left slide assembly and place it on a smooth work surface. Place the right slide assembly to the right of the left slide assembly. Position both rails so that the center brackets are facing upwards. NOTE: The slide assemblies are factory configured for center-mount use. For flush-mount installation, you must remove, rotate 180 degrees, and reinstall the mounting bracket on the opposite slide assembly. 2 Remove two locking nuts and two shoulder washers from each center bracket. Rack Installation Guide 1-15