Dell PowerEdge 2550 Rack Installation Guide - Page 30
Four-Post RapidRails Rack Installation Tasks, Marking the Rack, Installing the cable management arm
View all Dell PowerEdge 2550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
www.dell.com | support.dell.com Four-Post RapidRails Rack Installation Tasks Installing a four-post RapidRails rack kit includes the following tasks: 1 Marking the rack 2 Installing the slide assemblies in the rack 3 Installing the system in the rack 4 Installing the cable management arm Marking the Rack You must allow 2 U (3.5 inches) of vertical space for each system you install in the rack. Figure 1-19. One Rack Unit 1.75 inches (1 U) For more information about requirements for installing components in a Dell rack, see the Dell Rack Advisor software available on the Dell Web site at http://support.dell.com. CAUTION: If you are installing more than one system, install the slide assemblies so that the first system is installed in the lowest available position in the rack. 1-24 Rack Installation Guide