Dell PowerEdge T710 Hardware Owner's Manual - Page 146
in the chassis. See away the top edge, removing the metal hooks from the securing slots
View all Dell PowerEdge T710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
3 Rotate the system feet inward and lay the system on a flat surface. 4 Open the system. See "Opening the System" on page 85. CAUTION: Do not pull on the control panel cable to unseat the connector. Doing so can damage the cable. 5 Disconnect the control panel cable from the system board (see Figure 3-28): a Squeeze the metal tabs on the ends of the cable connector. b Gently work the connector out of the socket. 6 Remove the outer cover from the top side of the chassis to access the remaining control panel screw. a Using a #2 Phillips screwdriver, remove the two hex-head Phillips screws securing the outer cover from the back of the system. b Pressing firmly on the front edge of the cover, slide the cover slightly towards the back of the system. See Figure 3-28. c Remove the cover by first pulling away the bottom edge, then pulling away the top edge, removing the metal hooks from the securing slots in the chassis. See Figure 3-28. 7 Using a T10 Torx driver, remove the control panel screws that secure the control panel to the chassis. See Figure 3-28. 8 Slide the control panel assembly with the control panel cable out of the the chassis. See Figure 3-28. 9 Remove the control panel cable from the control panel board. See Figure 3-28. 146 Installing System Components