Dell PowerEdge T710 Hardware Owner's Manual - Page 46
BIOS. The BIOS setting has, Mirroring mode. See
View all Dell PowerEdge T710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Memory set to minimum frequency. The memory frequency may If not an intentional setting, be intentionally set lower for check any other system power conservation. messages for possible causes. The current memory Ensure that your memory configuration may support configuration supports the only the minimum frequency. higher frequency. See "General Memory Module Installation Guidelines" on page 98. Memory tests terminated by keystroke. POST memory test was terminated by pressing the spacebar. Information only. MEMTEST lane failure detected on x Invalid memory configuration. Mismatched memory modules are installed. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 98. Mirror mode disabled. For mirror mode, DIMMs must be installed in pairs. Pairs must be matched in size and geometry. The memory configuration Reconfigure the memory does not match the setting in modules for Memory BIOS. The BIOS setting has Mirroring mode. See been disabled. "System Memory" on page 98. 46 About Your System