Dell PowerEdge T710 Hardware Owner's Manual - Page 52
Unsupported CPU - firmware
View all Dell PowerEdge T710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Unable to launch System Services image. System halted! System halted after F10 Restart the system and keystroke because System update the Unified Server Services image is either Configurator repository to corrupted in the system the latest software to restore firmware or has been lost due full functionality. See the to system board replacement. Unified Server The iDRAC6 Enterprise card Configuration user flash memory may be documentation for more corrupted. information. Restore the flash memory using the latest version on support.dell.com. See the iDRAC6 user's guide for instructions on performing a field replacement of the flash memory. Unexpected interrupt in protected mode Improperly seated memory modules or faulty keyboard/mouse controller chip. Reseat the memory modules. See "Troubleshooting System Memory" on page 167. If the problem persists, see "Getting Help" on page 193. Unsupported CPU combination Unsupported CPU stepping detected Processor(s) is not supported Install a supported processor by the system. or processor combination. See "System Battery" on page 144. Unsupported DIMM detected. The following DIMM has been disabled: x Invalid memory configuration. The system will run but with the specified memory module disabled. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 98. 52 About Your System