Dell PowerSwitch S4820T Installing the S4820T System - Page 22

Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post

Get Dell PowerSwitch S4820T PDF manuals and user guides View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

NOTE: Retain the castings for future rack requirements. It is not necessary to remove the rear flange castings. 1. Remove the castings from the front of each ReadyRails assembly, as shown in item 1 in the following figure. Remove the two screws from each front flange ear (on the switch side of the rail) with a Torx driver. 2. Attach one rail to the front post flange with two user-supplied screws, as shown in item 2 in the figure. Figure 5. Two-post Flush-mount Configuration 3. Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post flange with two user-supplied screws, as shown in item 3 in the figure. 4. Repeat this procedure for the second rail. 22 Install the Hardware

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
NOTE:
Retain the castings for future rack requirements. It is not necessary to remove the rear flange
castings.
1.
Remove the castings from the front of each ReadyRails assembly, as shown in item 1 in the following
figure. Remove the two screws from each front flange ear (on the switch side of the rail) with a Torx
driver.
2.
Attach one rail to the front post flange with two user-supplied screws, as shown in item 2 in the
figure.
Figure 5. Two-post Flush-mount Configuration
3.
Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post
flange with two user-supplied screws, as shown in item 3 in the figure.
4.
Repeat this procedure for the second rail.
22
Install the Hardware