Dell PowerSwitch S4820T Installing the S4820T System - Page 41
Connecting Three S4820T Systems
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
You can use any of the RJ-45 or QSFP+ ports for stacking, provided you configure ports as stacking ports. To connect two S4820T systems in a ring, as shown in the figure, start with the S4820T at the bottom of the stack and follow these steps: NOTE: The port numbers in the following procedure are examples only. 1. Insert one end of the first cable into stack port 60 in chassis 1 (bottom). 2. Insert the other end of the same cable into stack port 52 on chassis 2 (top). 3. Insert a second cable into stack port 56 on chassis 2 (top). 4. Insert the other end of the second cable into stack port 56 on chassis 1 (bottom). Connecting Three S4820T Systems CAUTION: Use only Dell Networking-supported stacking cables to connect S4820T systems. To provide backup connectivity and increased data transfer between the systems, Dell Networking recommends inserting an additional cable between the units, in a second stacking port. Refer to the following figure. Connecting the Stacking Ports (Optional) 41