Dell S3048-ON Networking S3048–ON Getting Started Guide - Page 21

Enter the Initial Configuration Information, IP Settings, Navigating CLI Modes

Get Dell S3048-ON PDF manuals and user guides View all Dell S3048-ON manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Enter the Initial Configuration Information To set up the switch, assign an IP address and other configuration information necessary for the switch to communicate with the local routers and the Internet. The minimal configuration provided here does not cover most of the features; it simply allows you to perform other configuration tasks using a Telnet connection from your management network. NOTE: To configure other features and interfaces, refer to the Dell Networking OS Configuration Guide for the S3048 System. IP Settings To set up the switch, get the following information from your network administrator: • Switch IP address • Subnet mask (IP netmask) • Default gateway (router) • Enable secret password • Enable password • Telnet password Navigating CLI Modes The Dell Networking OS prompt changes to indicate the CLI mode. You must move linearly through the command modes, except for the end command which takes you directly to EXEC Privilege mode and the exit command which moves you up one command mode level. Dell Networking OS 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
Enter the Initial Configuration Information
To set up the switch, assign an IP address and other configuration information
necessary for the switch to communicate with the local routers and the Internet.
The minimal configuration provided here does not cover most of the features; it
simply allows you to perform other configuration tasks using a Telnet connection
from your management network.
NOTE:
To configure other features and interfaces, refer to the
Dell Networking
OS Configuration Guide for the S3048 System
.
IP Settings
To set up the switch, get the following information from your network
administrator:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
•
Telnet password
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
You must move linearly through the command modes, except for the
end
command which takes you directly to EXEC Privilege mode and the
exit
command
which moves you up one command mode level.
Dell Networking OS
21