Dell S3048-ON Networking S3048–ON Getting Started Guide - Page 25
Accessing the System Remotely, Configuring the Management Port IP Address
![]() |
View all Dell S3048-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Accessing the System Remotely You can configure the S3048-ON system to be accessed remotely by Telnet. The system has a dedicated management port and a management routing table that is separate from the IP routing table. 1 Configure an IP address for the management port (Configuring the Management Port IP Address). 2 Configure a management route with a default gateway (Configuring the Management Route). 3 Configure a username and password (Configuring the Username and Password). Configuring the Management Port IP Address In order to access the system remotely, assign IP addresses to the management ports. 1 Enter INTERFACE mode for the Management port. CONFIGURATION mode interface ManagementEthernet slot/port 2 Assign an IP address to the interface. INTERFACE mode ip address ip-address/mask 3 Enable the interface. INTERFACE mode no shutdown Configuring the Management Route Define a path from the S3048-ON to the network from which you are accessing the S3048-ON remotely. Management routes are separate from IP routes and are used to manage the S3048-ON through the management port. Dell Networking OS 25
![](/manual_guide/products/dell-s3048on-networking-s3048x2013on-getting-started-guide-cba1c6d/25.png)