Dell S5148F-ON Open Networking Hardware Diagnostic Guide September 2017 - Page 19
Dell EMC DIAG OS, Diagnostic package download
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4 Dell EMC DIAG OS The following describes the Dell EMC diagnostics. These instructions apply to systems for which the ONIE diagnostics are not available. Topics: • Diagnostic package download • View DIAG versions • View CPLD versions • Install or upgrade DIAG tools • Restore factory defaults Diagnostic package download Load or update the DIAG-OS (diag installer image) using the onie-nos-install command in ONIE Install or ONIE-Rescue mode. The DIAG-OS installer runs in two modes: Update mode or Install mode. • In Update mode, the DIAG-OS updates the existing DIAG-OS and boots back to ONIE. • In Install mode, the DIAG-OS erases the existing DIAG-OS and loads the new DIAG-OS. NOTE: If you have a recovery USB plugged into your system, remove it before installing the DIAG-OS using the onie-nosinstall command. NOTE: Before you begin, go to www.dell.com/support and download the diagnostic package. 1 Enter the onie-discovery-stop command to stop ONIE Discovery mode. 2 Assign an ip address to the management interface and verify the network connectivity. ONIE:/ # ifconfig eth0 xx.xx.xx.xx netmask xxx.xxx.x.x up ONIE:/ # ifconfig eth0 Link encap:Ethernet HWaddr 34:17:EB:05:B4:00 inet addr:xx.xx.xx.xx Bcast:xx.xx.xxx.xxx Mask:xxx.xxx.x.x inet6 addr: fe80::3617:ebff:fe05:b400/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:43 errors:0 dropped:0 overruns:0 frame:0 TX packets:31 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:5118 (4.9 KiB) TX bytes:7104 (6.9 KiB) Memory:dff40000-dff5ffff 3 Upgrade the DIAG Installer. Again, boot to ONIE Rescue mode and install the onie diag installer. Removing the existing DIAG OS and installing a new version example NOTE: In Install mode, the DIAG-OS installation removes any existing NOS and DIAG-OS partition. If you do not create file /tmp/diag_os_install_mode, the DIAG-OS installs in Upgrade mode. In this case, the installation process does NOT touch any existing NOS. ONIE:/ onie-nos-install tftp:////filename/diag-install er-x86_64-dell__c2538-r0-2016-08-12.bin discover: installer mode detected. Dell EMC DIAG OS 19