Dell S5148F-ON Open Networking Hardware Diagnostic Guide September 2017 - Page 46

• Address Walking 0-Walks a 0 address bit through the memory area available to it. Address walking 0 writes the additive inverse of the address to the location. After writing all addressed locations, it walks back through and verifies the locations data. • Data Read-Reads transactions similar to the Address Read test, but focuses on the data bits. Patterns are placed on the data bus to test for stuck data bits. • Data Write-Places data patterns on the bus for testing the bus and looks for stuck data bits. • Data Walking 1-Walks a 1 through the data bits within an address location and verifies that the values are valid before overwriting. • Data Walking 0-Walks a 0 through the data bits and verifies the value as it is testing. • Data Sliding 1-Slides a 1 through the data testing for stuck bits. By xor of each shift to the data, when finished, the cell holds all the 1s. • Data Sliding 0-Slides a 0 through the data bits set to 1. By xor of each shift of the data, when finished, the cell holds all the 1s. • Data Pattern-Writes four different patterns to memory locations within the specified region. The patterns are 0xFFFF, 0xFF00, 0xF0F0, 0xAAAA, 0xAA55 and 0x5555. The patterns are written as repeated portions of these patterns in the memory to fill the memory and as Hamming patterns (such as Hamming [8,4], Hamming[16,11], Hamming[32,26] or Hamming[64,57]) encoding with the additional most significant byte (MSB) parity bit to cover the parity bits in the Hamming code. This pattern allows for detecting multiple bit errors. • Data Cache-Performs a rotation of a 16MB array in four clockwise rotations for 16 iterations of the complete rotation. The 16MB size ensures that memory is not within the cache lines and causes cache ejections through each of the rotations. CLI options DellEmc Diag - Memory Tool version 1.5, x.xx.x.x-x build, 2017/05/23, Syntax: memtool Show the Help-text:= memtool --h (or) memtool -h Display the configuration info of the device:= memtool --info (or) memtool -i List all of the memory regions in the config file:= memtool --list (or) memtool -l Test using the MEM test config file:= memtool --test --region= [--testlist=,...] (or) memtool -t -G [-T ,,...] Read the specified physical address:= memtool --read --addr= --count= [--width=] (or) memtool -r -a -C [-W ] Write at the specified physical address:= memtool --write --addr= --val=,, ... , [--width=] (or) memtool -w -a -V ,..., [-W ] Execute repeatedly command by count:= memtool --iteration=max/ [option1] [option2]... (or) memtool -I max/ [option1] [option2]... Usage:= -h, --h -t, --test -i, --info -l, --list -G, --region -T, --testlist -I, --iteration= -C, --count= -a, --addr= -r, --read -w, --write -V, --val= -W, --width Show the help text Test using the pre-programmed configuration or use supplied config Configuration information List the understood TLV codes and names Region List of tests Iteration command execution Count Address Read operation Write operation Value to be set Width {8,16} 46 Dell EMC DiagOS tools