Dell Studio 1569 Service Manual - Page 30
Wireless Mini-Cards - wireless not working
View all Dell Studio 1569 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Back to Contents Page Wireless Mini-Card(s) Dell™ Studio™ 1569 Service Manual Removing the Mini-Card(s) Replacing the Mini-Card(s) Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface. CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. CAUTION: When the Mini-Card is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in the safety instructions that shipped with your computer). NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell. NOTE: Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed in the slot. If you ordered a wireless Mini-Card with your computer, the card is already installed. Your computer supports two Mini-Card slots: l One full Mini-Card slot - Wireless Wide Area Network (WWAN) l One half Mini-Card slot - Wireless Local Area Network (WLAN) Removing the Mini-Card(s) 1. Follow the procedures in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Loosen the two captive screws that secure the Mini-Card cover to the computer base. 4. Lift the Mini-Card cover at an angle and ease the tabs out of the computer base. 1 Mini-Card cover 3 tabs (2) 2 captive screws (2) 4 computer base 5. Disconnect the antenna cables from the Mini-Card. 6. Remove the screw that secures the Mini-Card to the system board.