Dell Vostro 15 5510 Service Manual - Page 51

Adhere the tape that secures the display cable to the system board

Get Dell Vostro 15 5510 PDF manuals and user guides View all Dell Vostro 15 5510 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Steps 1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly. 2. Using the alignment posts, close the display hinges. 3. Replace the three (M2.5x4.5) screws that secure the right-display hinge to the system board. 4. Replace the three (M2.5x4.5) screws that secure the left-display hinge to the system board. 5. Slide the display cable into the connector on the system board and close the latch to secure the cable. 6. Adhere the tape that secures the display cable to the system board. Next steps 1. Install the base cover. 2. Exit Service Mode. 3. Follow the procedure in After working inside your computer. Removing and installing components 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
Steps
1.
Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
2.
Using the alignment posts, close the display hinges.
3.
Replace the three (M2.5x4.5) screws that secure the right-display hinge to the system board.
4.
Replace the three (M2.5x4.5) screws that secure the left-display hinge to the system board.
5.
Slide the display cable into the connector on the system board and close the latch to secure the cable.
6.
Adhere the tape that secures the display cable to the system board.
Next steps
1.
Install the
base cover
.
2.
Exit
Service Mode
.
3.
Follow the procedure in
After working inside your computer
.
Removing and installing components
51