Epson C31CA85090 Reference Guide - Page 43
For Built-in USB Interface, he ser, al or parallel, erface, ecessary, o cha, he DIP sw, ch se, es.
View all Epson C31CA85090 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 Setup For Built-in USB Interface When using the serial or parallel interface, it is not necessary to change the DIP switch setting but their function changes. For the details, see "For Serial Interface" on page 40 and "For Parallel Interface" on page 42. DIP Switch Bank 1 SW Function ON OFF Factory setting 1-1 Auto line feed Always enabled Always disabled OFF 1-2 Receive buffer capacity 45 bytes 4 KB OFF 1-3 Undefined 1-6 - OFF 1-7 Undefined - * Setting of USB power-saving 1-8 function Disabled Enabled OFF 2 * Varies depending on the interfaces. DIP Switch Bank 2 SW 2-1 2-2 2-3 2-4 2-5 2-6 2-7 2-8 Function ON OFF Handshaking (BUSY condition) Offline Receive buffer full Receive buffer full Reserved (Do not change setting) Fixed to OFF Selects print density See "Selecting the Print Density (DIP Switches 2-3/2-4)" on page 45. Releases the BUSY Releases the BUSY Sets the release condition of the state when the state when the receive buffer BUSY state. (This remaining capacity remaining capacity function is effective when DIP of the receive buffer of the receive buffer Switch 1-2 is set to off.) reaches 138 bytes. reaches 256 bytes. Reserved (Do not change settings) Fixed to OFF Reserved - Factory setting OFF OFF OFF OFF OFF * * Varies depending on the interfaces. For DIP Switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 46. Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer may not operate normally. 43