Epson LX-300II User's Guide - Page 35

Selecting a Built-in Font, Sans Serif Condensed

Get Epson LX-300II - LX-300+ II Impact Printer PDF manuals and user guides View all Epson LX-300II manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Selecting a Built-in Font It is best to use your application program to select the font you want to use in a document. However, you may sometimes need to select one of the printer's six built-in fonts using the buttons on the control panel, as described below. (The settings you make in application programs usually override settings you make from the printer's control panel.) ❏ Draft ❏ Roman ❏ Sans Serif ❏ Draft Condensed ❏ Roman Condensed ❏ Sans Serif Condensed Follow these steps to use the control panel to select a built-in font: 1. Make sure that the printer is on but not printing. 2. Hold down the Pause button for three seconds to enter Micro Adjust mode. The Pause light begins to flash and the two Tear Off (Font) lights show the current font selection. 3. Press the Tear Off (Font) button repeatedly to cycle through the fonts, and stop when the lights on the control panel indicate the font you want. Your selection stays in effect until you change it again. Using the Control Panel 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Using the Control Panel
35
Selecting a Built-in Font
It is best to use your application program to select the font you want to
use in a document. However, you may sometimes need to select one of
the printer’s six built-in fonts using the buttons on the control panel, as
described below. (The settings you make in application programs usually
override settings you make from the printer’s control panel.)
Follow these steps to use the control panel to select a built-in font:
1.
Make sure that the printer is on but not printing.
2.
Hold down the
Pause
button for three seconds to enter
Micro Adjust mode. The Pause light begins to flash and the two
Tear Off (Font) lights show the current font selection.
3.
Press the
Tear Off (Font)
button repeatedly to cycle through the
fonts, and stop when the lights on the control panel indicate the font
you want. Your selection stays in effect until you change it again.
❏
Draft
❏
Draft Condensed
❏
Roman
❏
Roman Condensed
❏
Sans Serif
❏
Sans Serif Condensed