Epson Stylus Pro 7900 Proofing Edition Setup Guide ( Epson SpectroProofer &tra - Page 19
Initializing the SpectroProofer, Printer Guide
View all Epson Stylus Pro 7900 Proofing Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Setting Up the SpectroProofer | 19 Note: The SpectroProofer does not have a power switch. It is on when it is plugged in and receiving power. Initializing the SpectroProofer The SpectroProofer must be aligned before you use it for the first time. You only need to perform this procedure once. You don't need to repeat the alignment if you remove and re-install the SpectroProofer. 1. Confirm that the SpectroProofer is powered on by checking its green status light. The SpectroProofer must be powered on before you turn on the printer, or it won't be recognized. 2. Turn on the printer. 3. Load 24-inch or 44-inch roll paper in your printer, depending your model. Follow the paper loading instructions in your Printer Guide. 4. Select OPTIONS SETUP, SpectroProofer, DEVICE ALIGNMENT and EXECUTE, and then press the OK button on the printer's control panel. The printer automatically prints out and measures an adjustment pattern. This process takes about one minute to complete. 5. When the alignment is complete, READY is displayed on the printer's control panel. Your SpectroProofer is now properly installed. See the manual that came with your RIP or color measuring software for instructions on using the SpectroProofer. 19