Epson SureColor F7200 User Manual - Page 71
Drying Time Per Pass, Printable Side
View all Epson SureColor F7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Options Head Alignment Heating & Drying Media Suction Head Movement Multi-Strike Printing Roll Type Tension Measurement Description Select one of the following when print results are grainy or out of focus: Manual(Bi-D): when printing in both directions. Manual(Uni-D): if the previous setting does not improve the results. Set any of the following: Heater Temperature: from 86 to 131 °F (30 to 55 °C). Drying Time Per Pass: from 0.0 to 10.0 seconds. You can maintain a constant drying time by basing it on the media width. After Heater Feed: feeds media to the after heater after printing (if the media will be cut before the next job starts). Blank Area Feed: speeds up feeding of blank areas, from Mode 0 (highest speed) to Mode 3. Set from 0 to 10 to increase the gap between the print head and thin or flexible media. If print quality is reduced or media does not feed correctly, you may need to lower the suction. Selects the range of print head movement: Data Width: increases print speed by restricting movement to the printed area. Printer Full Width: provides more even print results. Select the number of times each line is printed, from 2 to 8 (or select Off to disable) Select Printable Side Out or Printable Side In based on how the media is rolled. Selects how often tension is measured and automatically adjusted: Periodically: recommended for most media. Every page: provides more precise tensioning (but slower printing). 71