Epson U220B Technical Reference - Page 128
Please store it as an extra screw in case you need it.
View all Epson U220B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
2. Loosen the detector adjustment screw a little bit by using a tool such as a coin and then loosen the screw gently by hand as until it stops. It must not be removed completely. detector adjustment screw 3. Remove the two screws of the roll paper guide. roll paper guide For a model that does not have a roll-paper near-end detector , jump to step 6. 4. Rotate the detector lever on the roll paper guide to change its direction. Note: After the direction of the detector lever is changed, be sure that the cable is connected to the connector firmly. detector lever cable 5. Tighten the detector adjustment screw. 6. Align the hole on the roll paper guide with the hole on the roll paper holder to match your roll paper width and then tighten the screw (3×10). Note: You will not use one of the two screws that have been removed when the roll paper guide is removed. Please store it as an extra screw in case you need it. B-4 How to Install the Printer on a Wall with the WH-10 Rev. D