HP 1050c Service Manual - Page 139
Do NOT use Clear Film, Vellum or Natural Tracing Paper., Press Enter
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Service Calibrations WARNING 3 If you selected to continue, then the following message appears on the front panel if media is not loaded. You must load Media in to the Printer to continue. Do NOT use Clear Film, Vellum or Natural Tracing Paper. Please, load paper to perform this operation and try again Press ENTER to continue Top Back ↑ ↓ Enter Press Enter 4 The Printer will start to print the Alignment Pattern and the following message will be displayed on the front panel: PRINTHEAD ACCESS Aligning printheads Approximate time remaining 6 min 30 sec 5 Once the Pen Alignment calibration is completed, the following message will be displayed on the front panel: Pen Alignment calibrated. Press ENTER to continue Top Back ↑ ↓ Enter Press Enter 6 If the calibration fails Perform the Electronic Systems Test ⇒ Page 4-5. HP DesignJets 1050C and 1055CM Printers Service Manual 5-23