HP 1050c Service Manual - Page 267
Restarting the printer - setup guide
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 267 highlights
Removal and Installation CAUTION The complete ink tube system is full of ink. 15. Now you can remove the complete Tubes System from the printer by sliding the tubes from between the tube guides. NOTE Restarting the printer 1 Turn the printer ON from the main power switch at the rear of the printer and from the power switch on the front panel. 2. The front panel displays: System StaSrytusptem Startup Press Enter to Continue C4704034 3. Press the Enter button. 4. Lift up the window and install four setup printheads into the Printhead carriage. (Refer to the User's Guide for details). 5. Install the Ink Cartridges. (Refer to the User's Guide for details). 6. The front panel displays: InitializingSpyrsitnetmerStartup PWraeists Enter to Continue C4704034 7. Wait for about 30 seconds. 8. Remove the setup printheads from the printer carriage. 9. Install the Printheads and the Printhead Cleaners (Refer to the User's Guide for details). You must perform the following Service Calibrations after the installation of the Tubes System. n Calibrations Backup ⇒ Page 5-19. n Pen Alignment ⇒ Page 5-22. HP DesignJets 1050C and 1055CM Printers Service Manual 8-59