HP 1050c Service Manual - Page 45
The Service Configuration Print - designjet serial number
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
System Error Codes System Error: 06030B Problem Description: The Ambient Temperature measured is out of the normal range. Corrective Action: Try the following: n Make sure that the Ambient temperature is within the allowed range (between 0 and 55 Degrees Centigrade). n Replace the Electronics Module ⇒ Page 8-25. System Error: 070100 XXXXXXXX (Non-Continuable) Problem Description: Firmware Error. Corrective Action: Power the Printer OFF and ON again to see if the System Error disappears. If the Error Code reappears, then report the error to the HP response Center or the nearest HP Support Office, stating the following information. n Model and Serial Number of the printer. n Which firmware revision the printer is using (See Note below). Check firmware in Utilities / Statistics / Code rev. n The complete error number (See Note below). n The Service Configuration Print ⇒ Page 1-19. n The Current configuration sheet. n Which software application the customer is using (name, version, etc.). NOTE When reporting the System Error Code, make sure that you supply the full Error Code (including the last 8 numbers where applicable) and the firmware version. Without this information, HP Support Personnel cannot help you. HP DesignJets 1050C and 1055CM Printers Service Manual 2-11