HP 14-bs000 Maintenance and Service Guide - Page 74
Display assembly, and then remove the cable from
View all HP 14-bs000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Display assembly This section describes removing the display assembly and disassembling display subcomponents. You must remove the display from the computer to disassemble certain display subcomponents. You can remove the bezel, camera, and raw display panel without removing the display. See Display subcomponents (bezel, panel, camera) on page 37 for more information. Before removing the display assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 32). 5. Remove the optical drive (see Optical drive on page 34), if installed. 6. Remove the bottom cover (see Bottom cover on page 41). To remove the display assembly: 1. Disconnect the display panel cable from the system board (1), and then remove the cable from the routing path in the computer (2). 2. Remove the antenna cables from the WLAN module (3), and then remove the cables from their routing path in the computer (4). 3. Remove the four Phillips PM2.5×5.0 screws (1) (two from each hinge) that secure the display assembly to the computer. 4. Lift the display to bend the hinges upward (2). 66 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts