HP 240 HP 450 Notebook PC and HP 455 Notebook PC Maintenance and Service Guide - Page 58
Remove the Phillips PM2.0×3.0 screw, To remove the WLAN module
View all HP 240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
To remove the WLAN module: 1. Loosen the memory module/wireless module compartment cover screw (1), and then lift up on the tab (2) and remove the cover (3). The memory module/wireless module compartment cover is available in the Plastics Kit. For more information about the Plastics Kit, see Plastics Kit on page 26. 2. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The #1 WLAN antenna cable is connected to the WLAN module Main terminal. The #2 WLAN antenna cable is connected to the WLAN module Aux terminal. 3. Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.) 4. Remove the WLAN module by pulling the module away from the slot at an angle (3). 50 Chapter 4 Removal and replacement procedures