HP 6120XG HP ProCurve Series 6120 Blade Switches Advanced Traffic Management G - Page 278
Output Displaying fip-snooping show Command, The FC-MAP index must be between 1 and 8.
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
Converged Enhanced Ethernet on the HP ProCurve 6120XG Switch FIP Snooping FIP Snooping Information FIP Snooping : Enabled FC_MAP table Index | FC-MAP 1 | 0xefc00 (Default) FCF_MAC table Interface | FCF_MAC Address 24 | 00059b-70f380 Figure 6-13. Output Displaying fip-snooping show Command These warning/error messages can appear when FIP Snooping is being configured. Only eight FC-MAPs can be configured globally to the box. If the user attempts to configure a FC-MAP index less than 1 or greater than 8, the following error message is displayed: The FC-MAP index must be between 1 and 8. If the user attempts to configure a FC-MAP that is already configured on the switch, the following error message is displayed: An entry already exists with this FC-MAP. By FC-BB5 standards, FC-MAP should be in the range 0xEFC00 - 0xEFCFF. If the user attempts to configure a FC-MAP outside this range, the following error message is displayed: The FC-MAP must be in the range EFC00-EFCFF. If the user attempts to remove the configured FC-MAP, the following log message is logged and displayed: Connections established using FC-MAP have been removed. The ProCurve switch supports only eight FC Fabrics. By default there is one default FC-MAP support. This FC-MAP configuration is also user editable. If global FIP Snooping is already enabled and the user attempts to remove the last FC-MAP, the following error message is displayed: Last FC-MAP cannot be removed as FIP Snooping is enabled. 6-24