HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 14

Resolved Caveats • CSCth94904 An internal switch port is down when one of these HP Flex 10-Gigabit Ethernet network interface cards (NICs) is up: - Flex 522m Mezz - Flex 542m Mezz - Flex 552m Mezz The workaround is to use the speed nonegotiate interface configuration command on the internal port. • CSCto57605 If the Dynamic Trunking Protocol (DTP) is set to speed nonegotiate for two switches that interface each other, and the speed/duplex is configured as full/1000, the speed/duplex configuration of one of the switches changes to auto/auto when the switch is restarted. The port channel becomes incompatible and the second switch's operation is suspended. This problem applies only to the 1000BASE-LX interface. The workaround is to enter the shutdown interface configuration command followed by the no shutdown command. • CSCtx73953 A port that is programatically configured with auth-default ACL does not allow any traffic on the switch except DHCP traffic. If the configurations on the interface are cleared and the interface is restarted, the auth-default ACL configuration remains and the problem persists. There is no workaround. Resolved Caveats • Caveats Resolved in Cisco IOS Release 12.2(55)SE5, page 14 • Caveats Resolved in Cisco IOS Release 12.2(55)SE4, page 17 • Caveats Resolved in Cisco IOS Release 12.2(55)SE3, page 19 • Caveats Resolved in Cisco IOS Release 12.2(55)SE2 and Earlier, page 20 Caveats Resolved in Cisco IOS Release 12.2(55)SE5 • CSCsy43147 During a Telnet session, the router crashes when the TACACS+ server is configured or unconfigured (tacacs-server host command) using the single-connection keyword. The workaround is to not use the single-connection keyword. • CSCtb35715 When you enter the show running-config interface configuration command, IP Service Level Agreement notifications are shown as enabled even when you have not enabled this configuration using the ip sla enable reaction-alerts interface configuration command. There is no workaround. Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(55)SE and Later 14 OL-22861-04