HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 33

Documentation Updates Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on Interface [chars] Explanation Authentication was successful. [chars] is the interface. Recommended Action No action is required. Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on [chars] Explanation The client MAC address could not be added to the MAC address table because the hardware memory is full or the address is a secure address on another port. This message might appear if IEEE 802.1x is enabled. [enet] is the client MAC address, and [chars] is the interface. Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses. If the client address is on another port, remove it from that port. Error Message SW_VLAN-4-VTP_USER_NOTIFICATION: VTP protocol user notification: [chars]. Explanation This message means that the VTP code encountered an unusual diagnostic situation. [chars] is a description of the situation. Recommended Action Find out more about the error by using the show tech-support privileged EXEC command. Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case with the TAC, or contact your Cisco technical support representative, and provide the representative with the gathered information. Updates to the Getting Started Guide This illustration in the Cisco Catalyst Blade Switch 3020 for HP Getting Started Guide has been updated: Figure 1 The Catalyst Blade Switch 3020 for HP 2 1 6 9 10 11 SYST STAT DLX SPD WS-CBS-M30O2D0E-HCPQONSOLE UID 17 20 MEDIA DETECT SFP/R-45 PORTS 17-20 17 17x 17x 21x 18 3 4578 19 20 20x 24x 18x 23x 24x 153139 1 Switch module 2 Release latch 3 System status LEDs 7 Health LED 8 SFP module port LEDs for ports 17 to 20 9 SFP module ports 17 to 20 OL-22861-04 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(55)SE and Later 33