HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 15

Resolved Caveats • CSCtc18841 If local proxy Address Resolution Protocol (ARP) is configured on the VLAN interface, the ARP entry for the Hot Standby Router Protocol (HSRP) enters into an incomplete state. The workaround is to remove the proxy ARP feature on the VLAN interface (by using the no ip local-proxy-arp interface configuration command) and restart the interface. • CSCtg38468 When AAA authorization is used with TACACS+, an error is displayed if the banner message (banner exec global configuration command) starts with a blank character. The workaround is to not start the banner message with a blank character. • CSCth00398 If the no vtp VLAN configuration command is used on a port that receives VTP updates, the switch does not process Layer 2 control traffic (STP and CDP) after some time. The workaround is to configure VTP on the port or to not use the no vtp command. • CSCtj22354 The switch fails when LLDP data units with Type Length Value (TLV) of more than 10 management addresses (MA) are received. The workaround is to disable the sending of LLDP MA TLVs on peer hosts. • CSCtj88307 When you enter the default interface, switchport, or no switchport interface configuration command on the switch, this message appears: EMAC phy access error, port 0, retrying...... There is no workaround. • CSCtj89743 CPU usage is high when a device connected to the switch is accessed using the https://IP_address command on the router. The workaround is to reload the device. • CSCtn10697 The switch crashes when DCHP snooping is enabled with value 125 and an offer packet is received. There is no workaround. • CSCto72927 If a Tcl policy is copied to the router, the router fails when an event manager policy is configured. There is no workaround. • CSCtq09233 If a CLI configuration text file is copied from a Windows system to the switch, a space is appended to the end of the macro description command when the file is read from the flash of the switch. This leads to errors resulting in high CPU utilization on the switch. Another possible issue is that the macro is not removed when the link goes down or the connected device is removed from the switch. The workaround is to copy the configuration file from a non-Windows system (like UNIX or Linux) or convert the file to an appropriate UNIX format before copying. OL-22861-04 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(55)SE and Later 15