HP Cisco Catalyst Blade Switch 3020 Release Notes for the Cisco Catalyst Blade - Page 19

Resolved Caveats Caveats Resolved in Cisco IOS Release 12.2(55)SE3 • CSCtg71149 When ports in an EtherChannel are linking up, the message EC-5-CANNOT_BUNDLE2 might appear. This condition is often self-correcting, indicated by the appearance of EC-5-COMPATIBLE message following the first message. On occasion, the issue does not self-correct, and the ports may remain unbundled. The workaround is to reload the switch or to restore the EtherChannel bundle by shutting down and then enabling the member ports and the EtherChannel in this order: - Enter the shutdown interface configuration command on each member port. - Enter the shutdown command on the port-channel interface. - Enter the no shutdown command on each member port. - Enter the no shutdown command on the port-channel interface. There is no workaround. • CSCth24267 The switch stack log displays an error message about the redundant power supply (RPS). No RPS is actually present and the switch is instead powered by the blade chassis. There is no workaround. • CSCth57488 The switch LEDs freeze or behave erratically. The problem occurs with bootloader version 12.2(44)SE5. There is no workaround. • CSCtl05835 For changes in temperature, the command line interface shows the updated temperature but the Simple Network Management Protocol (SNMP) always shows the temperature as "1 degree Celsius". There is no workaround. • CSCtn18139 When the show spanning-tree vlan VLAN interface fastethernet 0 command is entered, the switch restarts. The FastEthernet 0 interface is a management interface that does not run Spanning Tree Protocol (STP). Do not run show spanning-tree commands for management interfaces. • CSCtn57224 The switch sends out temperature traps when the temperature is between 58 and 60 degrees Celsius. There is no workaround. • CSCtn57245 The show env stack command displays RPS status as "RPS NOT PRESENT". This could confuse the customer because Blade switches do not support RPS. The workaround is to use the remote command all show env all command to display environment information. OL-22861-04 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(55)SE and Later 19