HP Indigo WS6600 Dripping Prevention and ITM Heating Hood Service -- CA393-101 - Page 34
Troubleshooting, Overview, ITM suction blower flow rate
View all HP Indigo WS6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
3 Troubleshooting This explains the troubleshooting process on how to service the dripping prevention system. Overview This explains the overview of troubleshooting process on how to service the dripping prevention system. ITM suction blower ● Amatek NautilAir blower CA345-42161 (spare part CU316-04281 BLOWER-NAUTILAIR 8.9 IN WITH TACHOMETER mfg P/N 150241-57-0). ● The blower should operate whenever the Press is connected to power (even in Off mode or Emergency Stop). ● For HP Indigo WS6000 Series Digital Presses with software v.8.9.1.I20 and above: in Printing mode, blower voltage should be 7.07 V. In the SysTab, miscEngineTopic > feedSuctionHighSpeedLevel = 730. At this value, the blower is at the optimal flow rate for the dripping reduction kit ( ≈ 240 L/sec). ● For HP Indigo WS6000 Series Digital Presses with software v.8.9.1 I20 I-fix1 and above, or for HP Indigo W7200 Series Digital Presses with software v.8.11 and above: in all modes except for Printing mode, Get Ready, Cold Start, and Pause, the blower control voltage is set to 5.57 V. In the SysTab, miscEngineTopic > feedSuctionLowSpeedLevel = 580. At this value, the flow rate is same as for the old model blower ( ≈180 L/sec). DC fan ( catch tray fan ) ● For software v.8.9.1 I20 I-fix1: the DC fan (IO_CS_CATCH_TRAY_FAN) operates only during Printing mode (not including Get Ready, Cold Start, or Pause mode). (for presses with external IHH) ● IHH unit blower and heater operates only during Printing mode. ● The IHH blower command voltage is 10 V. ● The heater set point is 70° C. ITM suction blower flow rate It references the ITM suction blower flow rate issues. Troubleshooting 31