HP Indigo WS6600 Dripping Prevention and ITM Heating Hood Service -- CA393-101 - Page 44
that the rubber seal is well mounted, and sealing the gap.
View all HP Indigo WS6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
10. Check that there is no gap between the external heater hood and rear press wall. Figure 3-9 Seal between the external heater hood and rear press wall 11. At the press rear, verify that the external heater hood fan is aligned with the suction duct. Verify that the rubber seal is well mounted, and sealing the gap. Figure 3-10 External heater hood fan seal 1 Suction duct 2 Fan 3 Seal Press in Shutdown 41
10.
Check that there is no gap between the external heater hood and rear press wall.
Figure 3-9
Seal between the external heater hood and rear press wall
11.
At the press rear, verify that the external heater hood fan is aligned with the suction duct. Verify
that the rubber seal is well mounted, and sealing the gap.
Figure 3-10
External heater hood fan seal
1
Suction duct
3
Seal
2
Fan
Press in Shutdown
41