HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 13

Preparing the HP NetServer, Overview of HP NetServer Preparation

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

2 Preparing the HP NetServer Overview of HP NetServer Preparation Follow the instructions in this chapter after you receive the Compaq rack-optimized kit. The existing LCD cover (metal housing around the LCD) on the front of the HP NetServer is too thick to accommodate the front bezel to be used in the Compaq rack. This chapter describes how to prepare the HP NetServer for the Compaq rack-optimized front bezel. The instructions in this chapter are summarized in the list below. l If the HP NetServer is connected, disconnect it. l If the HP NetServer is in a rack, extend it. l Remove the bezel latch. • Remove the existing control panel bezel. l Remove the top cover, fan cover, fans, and fan cage. l Disconnect the LCD cables. l Remove the existing LCD cover. l Install the new LCD cover. l Reconnect the LCD cables. l Reinstall the fan cage, fans, fan cover, and top cover. • Attach the new control panel bezel. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
9
2
Preparing the HP NetServer
Overview of HP NetServer Preparation
Follow the instructions in this chapter after you receive the Compaq
rack-optimized kit.
The existing LCD cover (metal housing around the LCD) on the front of the
HP NetServer is too thick to accommodate the front bezel to be used in the
Compaq rack. This chapter describes how to prepare the HP NetServer for the
Compaq rack-optimized front bezel. The instructions in this chapter are
summarized in the list below.
l
If the HP NetServer is connected, disconnect it.
l
If the HP NetServer is in a rack, extend it.
l
Remove the bezel latch.
•
Remove the existing control panel bezel.
l
Remove the top cover, fan cover, fans, and fan cage.
l
Disconnect the LCD cables.
l
Remove the existing LCD cover.
l
Install the new LCD cover.
l
Reconnect the LCD cables.
l
Reinstall the fan cage, fans, fan cover, and top cover.
•
Attach the new control panel bezel.