HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 40
Attaching the Slides to HP NetServer Chassis, Removing Lifting Handles
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 4 Installing into the Rack Figure 4-3. Attaching the Slides to HP NetServer Chassis 3. Line up the mounting holes in the slide members with the holes in the HP NetServer chassis, insert the four screws on each side and tighten them, as shown in Figure 4-3. 4. Remove the two screws from each of the four lifting handles and remove the handles, as shown in Figure 4-4. Keep these handles and screws for later use, in case you need to remove the HP NetServer and ship it. Figure 4-4. Removing Lifting Handles 36
Chapter 4
Installing into the Rack
36
Figure 4-3.
Attaching the Slides to HP NetServer Chassis
3.
Line up the mounting holes in the slide members with the holes in the HP
NetServer chassis, insert the four screws on each side and tighten them, as
shown in Figure 4-3.
4.
Remove the two screws from each of the four lifting handles and remove
the handles, as shown in Figure 4-4. Keep these handles and screws for
later use, in case you need to remove the HP NetServer and ship it.
Figure 4-4.
Removing Lifting Handles