HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 8
Order of Installation Operations, Received Kit, Awaiting Kit
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 1 NOTE Introduction Until you receive the Compaq rack-optimized front bezel, control panel bezel, and LCD cover: • Leave the HP-optimized control panel bezel in place. • Do not close the front door (if any) of the Compaq rack because it would interfere with the HP-optimized control panel bezel. • Do not remove the HP-optimized front bezel. Order of Installation Operations What you do when depends on whether you have received the Compaq rack-optimized kit when you first install the HP NetServer in the Compaq rack. Table 1-1 summarizes the following two alternatives: l Received Kit: If you already have received the Compaq rack-optimized kit, proceed through Chapters 2, 3, and 4 to prepare the HP NetServer, prepare the Compaq rack, and install the HP NetServer in the rack. l Awaiting Kit: If you want to install the HP NetServer in the Compaq rack before you receive the Compaq rack-optimized kit, refer to Chapters 3 and 4 to prepare the Compaq rack and install the HP NetServer in the rack. After you receive the kit, refer to Chapters 2 and 4 for installation instructions. 4