HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 26
LCD Board, Rear Half of, New LCD Cover, Retainer, Standoff,
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 2 Preparing the HP NetServer 2. Thread the LCD power cord and ribbon cable through the rectangular hole in the rear half of the new LCD cover, as shown in Figure 2-12. CAUTION Be careful not to pinch the LCD cables between the LCD board and the rear LCD cover. 3. Slide the LCD board into the rear half of the LCD cover, as shown in Figure 2-13. ◊ Place the LCD board under the two retainers. ◊ Place the LCD board in front of the three standoffs. Verify that the LCD board is positioned correctly as shown in Figure 2-13. Rear Half of New LCD Cover Retainer Standoff Standoff LCD Board Figure 2-13. Inserting the LCD Board into the New Rear LCD Cover 4. Orient the front half of the new LCD cover, as shown in Figure 2-12. Ensure that the front of the LCD is parallel to the front of the LCD cover. 5. Gently push the front half of the new LCD cover onto the rear half of the cover and the LCD. 6. Thread the LCD power cord and ribbon cable through the hole in the processor tray shown in Figure 2-14. 22