HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 22

Disconnect the LCD Cables, Ribbon Cable, Connector, Top Flap of Ribbon, Cable Connector

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Chapter 2 Preparing the HP NetServer Disconnect the LCD Cables A ribbon cable and a twisted-pair cable connect the LCD to the front panel board, as shown in Figure 2-9. (For clarity, the processor tray is not shown in the enlarged detail in the figure.) Front Panel Board Ribbon Cable Connector Twisted-pair Cable Connector Top Flap of Ribbon Cable Connector Processor Tray Figure 2-9. Disconnecting the LCD Cables (HP NetServer LXr 8500 Shown) CAUTION When disconnecting the LCD cables, pull the connector straight back from the socket. This protects the connector pins from being bent. Disconnect the LCD cables, as follows: 1. Pull the connector of the twisted-pair cable straight back in the direction shown in Figure 2-9. 2. Lift up on the top flap of the ribbon cable connector, and then pull the connector straight back in the direction of the arrow shown in Figure 2-9. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Chapter 2
Preparing the HP NetServer
18
Disconnect the LCD Cables
A ribbon cable and a twisted-pair cable connect the LCD to the front panel board,
as shown in Figure 2-9. (For clarity, the processor tray is not shown in the
enlarged detail in the figure.)
Ribbon Cable
Connector
Top Flap of Ribbon
Cable Connector
Twisted-pair Cable
Connector
Front Panel Board
Processor Tray
Figure 2-9.
Disconnecting the LCD Cables
(HP NetServer LXr 8500 Shown)
CAUTION
When disconnecting the LCD cables, pull the connector
straight back from the socket. This protects the connector pins
from being bent.
Disconnect the LCD cables, as follows:
1.
Pull the connector of the twisted-pair cable straight back in the direction
shown in Figure 2-9.
2.
Lift up on the top flap of the ribbon cable connector, and then pull the
connector straight back in the direction of the arrow shown in Figure 2-9.