HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 34
At Rear, Of Column, Unit Below, Intended Installation, Location,
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Chapter 3 Preparing the Rack To mark the slide mounting holes, refer to Figure 3-1 and do the following: 1. On the front columns, count up from the bottom of the installation location (which is the top of the unit below), marking the 4th and 6th holes. 2. On the rear columns, count up from the bottom of the installation location (which is the top of the unit below), marking the 4th and 6th holes. 6th 4th 6th 4th (At Rear Of Column) 17th 9th 6th 4th 6th 4th 17th 9th Unit Below Intended Installation Location Figure 3-1. Marking Holes for Installation 3. Now mark two holes on each of the front columns to use for the cage nuts where the HP NetServer-attachment screws secure to the columns. 4. To mark the HP NetServer-attachment holes on the front columns (refer to Figure 3-1), count up from the bottom of the installation location (which is the top of the unit below), marking the 9th, and 17th holes. 30