HP LH4r Compaq 4000/7000 Racks Installation Guide - Page 36
Mount the Slides, Column, Screws, Flange, Slide
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 3 Preparing the Rack 1. Loosen the two screws on the rear flange of the slide, but leave them in place. 2. Extend the rear flange by pushing it outward until the screws stop it. 3. Tighten the screws. NOTE The slides do not come apart; they are one piece. Mount the Slides 1. Orient each slide so that the front of the slide attaches to the front column and the rear attaches to the rear column. This ensures that, once installed, the slides will extend correctly toward the front of the rack. See Figure 3-3. Use either slide in either location; they are identical. 2. Place the mounting flange of the slide on the outside face of the column, as shown in Figure 3-4. Do this at the front and rear columns. Column Slide Flange Screws Figure 3-4. Mounting a Slide to a Column 3. Insert the two screws through the two holes in each flange and tighten the screws. 4. Repeat for the other slide. 5. Extend the slides until you hear a click, indicating they are fully extended in the locked-out position. Note that the slides do not come apart (see Figure 3-3). 32