HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 39

System Board System Board Retaining Latch VRM (166 MHz Processor) or Shunt (133 MHz Processor) Power Supply Connector Processor chip (133 or 166 MHz) Cache memory Memory SIMM Connectors Bank C Bank B Bank A Power Switch and Activity LED Connector Power Supply Connector IDE 1 Connector IDE 2 Connector Flexible disk connector Battery DIP Switch Package Display Monitor Connector Keyboard Connector Mouse Connector Com 1 Serial Port Connector Com 2 Serial Port Connector Parallel Port Connector System Board Switch Settings Switch position 1, 2, 3. & 4 Factory preset (See table below) 5 Open 6 Open 7 Closed 8 Open 9 Closed 10 Open Definition: Select processor speed settings. The switch positions may need to be changed when upgrading the processor. See the table below for required settings for your Intel 166 MHz CPU. Clears the password. Set the switch to the closed position and restart the NetServer to clear the password. Return the switch to the open position and restart the NetServer to return to normal operation. Resets the CMOS configuration to the default values. Set the switch to the closed position and restart the NetServer to reset the CMOS. Return the switch to the open position and restart the NetServer to return to normal operation. Reserved Reserved Enable or disable space bar power-on. If you want to enable this feature, set this switch to Closed. If you want to disable it, set this switch to Open. This feature must also be configured in the BIOS using the SETUP utility. Reserved 33