HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 50
Switch, position, Factory, preset, Definition
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
System Board Power Switch and Activity LED Connector System Board Retaining Latch Processor chip DIP Switch Package Battery Com 1 Serial Port Connector Com 2 Serial Port Connector Parallel Port Connector Mouse Connector Keyboard Connector Display Monitor Connector Memory SIMM Connectors Bank A Bank B Bank C Power Supply Connector IDE 1 Connector IDE 2 Connector Flexible disk connector System Board Switch Settings Switch position 1 - 5 6 Factory preset (See table below) Open 7 Open 8 Closed 9 Open 10 (See table below) Definition: Select processor speed settings. The switch positions may need to be changed when upgrading the processor (see table below). Resets the CMOS configuration to the default values. Set the switch to the closed position and restart the NetServer to reset the CMOS. Return the switch to the open position and restart the NetServer to return to normal operation. Clears the password. Set the switch to the closed position and restart the NetServer to clear the password. Return the switch to the open position and restart the NetServer to return to normal operation. Enable or disable space bar power-on. If you want to enable this feature, set this switch to Closed. If you want to disable it, set this switch to Open. This feature must also be configured in the BIOS using the SETUP utility. Open = normal operation Closed = Clear system product ID Sets the processor supply voltage (see table below). Open = 3.3V Closed = 3.5V 44