HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 47
I/O Boards, Boot Device Priority
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
I/O Boards System Board slot Slot 1- 16-bit ISA (half-length) or 32-bit PCI Slot 2- 32-bit PCI Slot 3- 32-bit PCI Slot 4- 16-bit ISA (half-length) or 32-bit PCI Slot 5- 16-bit ISA Slot 6- 16-bit ISA These slots allow you to install accessory boards as follows: • Slot 1 (the innermost) can be used for a short 16-bit ISA board or a 32-bit PCI board. • Slots 2 and 3 can be used for 32-bit PCI boards. • Slot 4 can be used for a full-length 16-bit ISA board or a 32-bit PCI board. • Slots 5 and 6 can be used for full-length 16-bit ISA boards The NetServer comes with a SCSI card preinstalled and configured in Slot 1, and a network interface card preinstalled and configured in Slot 3. NOTE If you are manually configuring an accessory board, avoid using COM1 and COM4, if possible, due to the possibilities of resource conflicts with some application software programs. Boot Device Priority 1. IDE CD-ROM Drive 2. Flexible Disk Drive 3. IDE hard disk drive 5. PCI slot devices in this order: • Slot 3 * • Slot 1 * • Slot 2 * • Slot 4 * * If any of these slots have a SCSI controller board, SCSI devices connected to this controller will boot in this order: • ID 0 • ID 1 • ID 2 • ID 3 41