HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 70
Memory, Boot Device Priority
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Front of Chassis Bottom of Chassis Installing the cover Memory The NetServer E 60's main memory is implemented with 3.3V, 100 MHz, unbuffered SDRAM DIMMs (Dual In-Line Memory Modules). The NetServer E 60 ships with at least 64 MB of main memory and supports up to 1 GB. Memory is available in the following DIMM capacities: 64, 128, and 256 MB. There are four DIMM sockets on the system board. DIMMs may be installed in any combination in any socket. However, HP recommends starting at socket 0 and filling the sockets in order: 1, 2, and 3. Use only HP DIMMs. Boot Device Priority 1. IDE CD-ROM Drive 2. Flexible Disk Drive 3. Embedded SCSI A 4. Embedded SCSI B 5. PCI 2 6. PCI 1 7. PCI 6 8. PCI 3 9. PCI 4 10. PCI 5 64
64
Bottom of Chassis
Front of Chassis
Installing the cover
Memory
The NetServer E 60's main memory is implemented with 3.3V, 100 MHz, unbuffered SDRAM DIMMs (Dual
In-Line Memory Modules). The NetServer E 60 ships with at least 64 MB of main memory and supports up to
1 GB. Memory is available in the following DIMM capacities: 64, 128, and 256 MB.
There are four DIMM sockets on the system board. DIMMs may be installed in any combination in any
socket. However, HP recommends starting at socket 0 and filling the sockets in order: 1, 2, and 3.
Use only
HP DIMMs.
Boot Device Priority
1.
IDE CD-ROM Drive
2.
Flexible Disk Drive
3.
Embedded SCSI A
4.
Embedded SCSI B
5.
PCI 2
6.
PCI 1
7.
PCI 6
8.
PCI 3
9.
PCI 4
10.
PCI 5