HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 86
SCSI ID Single Bus
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
SCSI Addresses Based on the selected cabling configuration (single or dual bus), the system automatically provides the SCSI addresses according to the following table: SCSI ID Reference Slot 1 2 3 4 5 6 7 8 SCSI ID Dual Bus 0 1 2 3 0 1 2 3 SCSI ID Single Bus 0 1 2 3 8 9 A B Switch Settings Switch Number Position Description 0 Channel 0 SCSI Ids OFF 0, 1,2,3 /E* ON 4, 5, 6, 7 /C* 1 Channel 1 SCSI Ids OFF 0, 1, 2, 3 /E* ON 8, 9, A, B /F* 2 Remote Start OFF ON Wait for host start command 3 Delayed Start OFF All drives spin up when power is applied ON Drives delayed by ID time 6 seconds 4 UPS InPlace NOT USED * Enclosure Management ID 80
80
SCSI Addresses
Based on the selected cabling configuration (single or dual bus), the system automatically provides the SCSI
addresses according to the following table:
SCSI ID Reference
Slot
SCSI ID Dual Bus
SCSI ID Single Bus
1
0
0
2
1
1
3
2
2
4
3
3
5
0
8
6
1
9
7
2
A
8
3
B
Switch Settings
Switch
Number
Position
Description
0
Channel 0 SCSI Ids
OFF
0, 1,2,3 /E*
ON
4, 5, 6, 7 /C*
1
Channel 1 SCSI Ids
OFF
0, 1, 2, 3 /E*
ON
8, 9, A, B /F*
2
Remote Start
OFF
<<Switch 3 controls startup>>
ON
Wait for host start command
3
Delayed Start
OFF
All drives spin up when power is applied
ON
Drives delayed by ID time 6 seconds
4
UPS InPlace
NOT USED
* Enclosure Management ID