HP LH4r HP Netserver Service Handbook, Volume 1 - Low End - Page 76
Processor Switch Settings
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
The switches and each of their definitions are listed below. Switch position 1 Factory preset OFF Definition: Off - let's you power on your system by pressing any key on the keyboard or the power-on button. On - let's you power on the system only by pressing the power-on button. 2 3 4 5 - 8 OFF OFF (See table below) Unused Clears the password. Set the switch to the ON position and restart the NetServer to clear the password. Return the switch to the OFF position and restart the NetServer to return to normal operation. Resets the CMOS configuration to the default values. Set the switch to the ON position and restart the NetServer to reset the CMOS. Return the switch to the OFF position and restart the NetServer to return to normal operation. Select processor speed settings. The switch positions may need to be changed when upgrading the processor (see table below). Processor Switch Settings The following table shows the settings for each Intel processor module. To set the switches correctly, observe the markings on the replacement processor module. Each processor module will have a speed marking. Use the table below to look up the appropriate switch settings for each of these CPUs. CPU Speed 400 MHz 450 MHz 500 MHz Switch 5 OFF ON OFF Switch 6 OFF OFF ON Switch 7 ON ON ON Switch 8 OFF OFF OFF Specifications Temperature Operating Non-operating 5°to 35°C (41°to 95°F) -40° to +65° C (-40° to +149° F) Humidity (non-condensing) Operating Non-operating 20% to 80% relative humidity, non-condensing 5% to 95% relative humidity, non-condensing Altitude Operating Non-operating -30 to 3,000 m (~ 10,000 ft) -30 to 12,000 m (~ 40,000 ft) Thermal Output Maximum Operating 1116 BTU/hr 70