HP LaserJet 4100 HP PCL/PJL reference (PCL 5 Printer Language) - Technical Ref - Page 109
Table 20-10, Example: Using the AT Command, Specify 1000, 100 as the starting
View all HP LaserJet 4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
z If the end point is the same as the current pen location, a circle is drawn, with its diameter being the line from the current pen position to the intermediate point. z If the current pen position, intermediate point, and end point are collinear, a straight line is drawn. z If the intermediate point does not lie between the current pen location and the end point, and the three points are collinear, two lines are drawn; one from the current pen location and the other from the end point, leaving a gap between them. Refer to the following illustration. Both lines extend to the PCL Picture Frame limits or current window. Figure 20-11 Table 20-10 Example: Using the AT Command ECE EC%ØB IN; Reset the printer. Enter HP-GL/2 mode. Initialize HP-GL/2 mode. SP1; Select pen number 1 (black). PA1000,100; PD2500,100; Specify (1000,100) as the starting location, place the pen down, and draw a line to (2500,100). PU650,1150; PD1000,1150; Lift the pen, move to (650,1150), place the pen down, and draw a line to (1000,1150). EN AT, Absolute Arc Three Point 20-17