HP LaserJet 4100 HP PCL/PJL reference (PCL 5 Printer Language) - Technical Ref - Page 210
Table 22-6, Example: Using the FT Command continued, PR0, 300;FT3
View all HP LaserJet 4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Table 22-6 Example: Using the FT Command (continued) PA2000,2000; Specify absolute plotting and move to location (2000,2000). FT;RR2500,300; ER2500,300; Select the default fill type (solid black); fill a rectangle using solid black fill, with the lower left corner being the current pen location and the upper right corner a point 2500 plu to the right and 300 plu up; edge the rectangle that was just filled. PR0,300;FT3,80,30 ; RR2500,300; Specify relative plotting and move the pen up 300 plu; select fill type number 3 (parallel lines), with 80 plu between each line, with each line tipped 30×; fill a rectangle with the just-specified fill, using the rectangle bounded at the lower left corner by current the pen location and a point 2500 X-units and 300 Y-units away as the upper right corner. PR0,300;FT10,36; RR2500,300; ER2500,300; Move the pen position up 300 plu; specify the fill type as 36% shading; fill a rectangle with 36% shading, with the lower left corner being the current pen location and the upper right corner 2500 plu to the right and 300 plu up from there; edge the outline of the same rectangle. ?%0A ?E Enter the PCL mode. Send a reset to end the job and eject the page. Figure 22-10 22-14 The Line and Fill Attributes Group EN